$0.00(0 items )

No products in the cart.

(440) 497-0250

Setting up a Harbor Freight Bar Bender for 90 deg bends in aluminum

Jun 20, 2020 by Brian Warner Category: Metal Working 0 comments

I love my little harbor freight bar bender. I use it for a lot of parts. We even use a few of them at my day job for bending lots of parts we shouldn’t be able to in quantities that exceed expectation. We have actually worn a few of them out bending 1000’s of 3/8″ stainless […]

Harbor Freight Bar Bender Set up, 90 deg, steel

Jun 20, 2020 by Brian Warner Category: Metal Working 0 comments

In the previous post about setting up the Harbor Freight Bar Bender, we bent some 5051 aluminum using the right angle attachment. Here, we will be bending 1/8″ x 1″ cold rolled 1018 steel. With this material, you can not use the right angle attachment, as the steel will actually fracture on the back side. On […]

Brian will be offline from 2/20-about 2/24 due to his wife's surgery. I will respond to emails and such after that. Also. no new orders will be processed until our last escape room installation is complete. Thank you for understanding and email us for any questions Dismiss